Overview

These are the standard settings to provide or verify with your processor when setting up a PAX Payment Terminal not hosted by RITE. This applies to Android devices:


Procedure

  1. Switch your Payment Terminal on. Make sure that the screen shows the normal payment screen and NOT the BroadPOS Menu Screen. If it's showing the BroadPOS Menu screen, this means that the application is not installed yet. 
  2. Please contact your processor and ask them to install the application before proceeding. You may need to power cycle the terminal once the processor verifies that the application is ready for download and installation.
  3. Once the application is installed, verify that the following configurations are in place:

MISC Tab

 This is where signature and receipt settings are configured


Field NameValue
Support PrintDisabled
Dedicated Device (Full Screen) ModeEnabled
Signature CaptureEnabled
EMV Signature CaptureEnabled
Signature with Cancel ButtonEnabled
Signature Typee-Signature
Print MID on ReceiptDisabled
Pre-PrintDisabled
Print Total Sales on Tip ReportDisabled
Reversal Prompt For Partial ApprovalEnabled
ECR-Terminal Integration ModeExternal POS


See the below image for additional reference:



EMV Tab

 These settings ensure that the EMV chip is read properly and that the tap feature will work correctly


Field NameValue
Enable EMV FeatureEnabled
CVM Required Limit0.00



See the below image for additional reference:



Communication Tab


Field NameValue
Primary Comm. TypeLAN
Port10009
Communication TypeEthernet
Protocol TypeTCP/IP

See the below image for additional reference:

References